Detailed description
Branding pieces are bought on how they survive the wash and the iron, not on how they look in a render. The specification that decides both is the material and the way it is attached.
Where it is used
It goes onto polyester sports fabric, cotton drill, nylon outerwear, canvas bags and caps. The one combination that fails most often is a heat transfer onto a coated or water-repellent fabric, because the coating releases before the adhesive cures.
The material question
This is a heat-transfer construction: the design is printed or moulded onto a carrier film and applied with a press. Adhesion depends on pressure, temperature and dwell being right on your press, not only on the film, so the first application is a trial rather than a production step.
How it is quoted
Minimum order is set by the sheet, not by the design: several small designs can share one run, which is how a club with six logos keeps the unit cost close to a single-logo order.
What ships with the goods
Wash-test results are reported per lot where the customer specifies a cycle count, and the test method is named on the report rather than described as 'washable'.
Checking it on arrival
Press one piece onto the actual fabric with your own settings before the run starts. The failure mode on transfers is almost always the press, not the film, and it is cheaper to find that on one piece than on five hundred.
Send the artwork, the fabric and the quantity and the quote comes back split into tooling and piece price so you can compare it against your current supplier line by line.